If your Raspberry pi is connected, you should be able to establish an ssh connection. You should see your raspberry pi in your wifi routers web interface.

Insert the SD-card into your Raspberry pi, connect a power source and wait for it to connect to your wifi. Navigate via terminal to the boot partition on your SD-card: } Code language: JavaScript ( javascript )Īdd an empty file called ssh without any content to the same partition to enable ssh.

via finder), with the following content: ctrl_interface=DIR= /var/run/wpa_supplicant GROUP=netdev To connect to your wifi network, add file called wpa_nf to partition “boot” (e.g. Please make absolutely sure, that the number (“X”) belongs to your SD-card! Sudo dd bs=1m if=theImagePath.img of=/dev/rdiskX conv=sync Let’s get started!ĭiskutil unmountDisk /dev/diskX ( X is the number of your SD-card you found out in the step before) All kinds of projects can be done with this setup as most of them do not require any external input devices or HDMI monitors. You just need a wifi connection as you will set up everything over ssh. When following this instruction, you do not need to connect any input devices for setting up your Raspberry Pi. However, these often include features you do not necessarily need and also setup is often dependent on input devices. What is special about this minimal setup?īasically, you could just install any of the preconfigured Linux distribution available.

Pi zero w wifi setup